3
U N PACKING
Carefully unpack the Unifence and all loose items from the shipping cartons. NOTE: Do not discard the card-
board template shipped with the Unifence as it will be used in the assembly.
If you purchased the 36-905 Unifence without the acces-
sory 34-914 table, a similar table must be constructed,
preferably of particle board.
1.
A 32 long by 27 wide table should be constructed
using 3/4 inch material by following the dimensions
shown in Fig. 2.
2.
Twelve 9/64 inch diameter holes must be drilled
5/8 inch deep in the bottom side of the table. These
twelve hole locations are shown in Fig. 2.
3.
Three undercuts must also be made on the bottom
left side of the table. The location of these undercuts are
shown in Fig. 2. The size of the undercuts are shown in
detail in Fig. 3. NOTE: On saws other than Delta, it may
be necessary to change the location of the three under-
cuts in the table depending on the position of the table
adapter plate mounting screws. Refer to section
ASSEMBLING TABLE ADAPTER PLATE TO SAW
TABLE.
4.
IMPORTA N T:
For maximum operational ease when
sliding the fence across the table, the top of the table
should be covered with a veneer.
Fig. 2
CONSTRUCTING UNIFENCE TA B L E
Fig. 3