18
Fig. 66
Fig. 67
Fig. 65
Fig. 64
Fig. 63
USING T H E F E N C E A S A C U T-OFF G A G E
RIPPING ON LEFT SIDE
OF SAW BLADE
In some cases it may be desirable to use the fence on
the left side of the saw blade. This is easily accomplished
by repositioning the fence (A) Figures 63 and 64, fence
clamp bar (B) and lock knobs (C) so that the fence (A)
will be attached to the right side of the fence body, as
shown in Fig. 64. The complete fence assembly (D)
Fig. 64, can easily be moved to the left side of the saw
table.
The fence can be used as a cut-off gage when cross
cutting a number of pieces to the same length. IMPOR-
TA N T:When using the fence as a cut-off gage, it is very
important that the rear end of the fence be positioned in
front of the saw blade. When using the fence as a cut-off
gage, simply position the fence (A) to the front as shown
in Fig. 65, or purchase the accessory 34-878, 12 long
fence (B), as shown in Fig. 66. Fig. 67, illustrates a
typical operation using the accessory 34-878 12 long
fence (B) as a cut-off gage.
C
A
B
A
D
C
A
B
B