Delta TP70P, Быстрый старт

Страница: 15 / 65

T P 7 0 P Q u i c k St a r t
1 - 1 2
1.8 Wiring
1.8.1 Wiring a Power Input Connector
The power supplied to TP70P is DC power. When users use TP70P, they have to note the following points.

Please connect wires to the ter24V and 0V. The power supplied to TP70P should be in the range
of 20.4 V DC to 28.8 V DC. If the voltage of the power supplied to TP70P is less than 20.4 V DC, TP70P
will stop running, and output devices will be off.

If a power cut is shorter than 10 milliseconds, TP70P will not stop running. If a short cut is long, or the
voltage of the power supplied to TP70P decreases, TP70P will stop running, and output devices will be off.
If power is restored after a power cut, TP70P will automatically resume running. (There are latching
auxiliary relays and retentive registers in TP70P. Users should use them carefully when they design a
program.)

The power supplied to TP70P is DC power. A Delta power supply module (DVPPS02/DVPPS05) can be
used to supply power to TP70P. In order to protect DVPPS02/DVPPS05, users need to have the protection
circuit shown below.
24V 0V
AC
10 0~24 0V
5 0/60H z
2A
DVP PS02
L
N
MC
TP7 0
24V
0V FE

AC power supply: 100~240 V AC, 50/60 Hz

Circuit breaker

Emergency stop: An emergency stop button can be used to cut off power when an emergency occurs.

Power indicator

AC load

2 A fuse

Ground (Impedance: Less than 100
Ω
)

DC power supply: 24 V DC