212385 Rev. A
www. s p e c s e l e c t . c o m
Page 7
BATTERY STRENGTH INDICATOR & BATTERY REPLACEMENT
TO CHECK BATTERY STRENGTH:
1.
During Operation Mode - press and hold down the electronic override button for approximately 10 seconds.
2.
DO NOT RELEASE BUTTON WHEN SOLID BLUE LIGHT IS PRESENT - KEEP HOLDING DOWN.
3.
After 10 seconds, the battery strength will be displayed via the red lights. The more lights that are present, the more life the batteries
have. See Figure 8.
4.
When you are satisfied with the strength indication, release the electronic override button to return to Operation mode.
TO REPLACE BATTERIES:
1.
Remove the two cover screws and lift off metal cover, see Figure 9.
2.
Hold case/cover securely with one hand and open hinged lid of the battery compartment in the
back of the unit.
3.
Pull the battery holder out and insert new set of four “AA” batteries into battery holder. (Use the +/-
signs on the batteries and the +/- signs on the battery holder for correct positioning.)
Note:
Do not use a metal screwdriver to remove snap from battery holder.
4.
Install the refreshed battery holder back into the electronic housing. (When the new batteries are
installed and connected, an initial ascending and descending red light sequence will occur.)
5.
Close the battery compartment lid ensuring wires are neatly tucked into compartment and are not
pinched between case and cover. Test the electronic override button. Blue light flashes once when
override is activated.
6.
Place the metal cover back onto flushometer and replace the two cover screws. DO NOT
OVERTIGHTEN. Flushometer is now ready for use.
NOTE:
All previously adjusted settings will be retained when batteries are changed.
1. Start-Up:
When batteries are first inserted, there is an initial ascending and descending red light
sequence that will occur.
2. Electronic Override Button in Operating Mode:
Blue light flashes once when Electronic
Override Button is activated.
3. Low Battery Level Indicator:
One RED light flashes every 15 seconds, indicating approximately
5,000 flushes remain from when RED light first started flashing.
Fig. 8
BATTERY STRENGTH INDICATION
VERY HEALTHY
- 5 RED LIGHTS
HEALTHY
- 4 RED LIGHTS
AVERAGE
- 3 RED LIGHTS
LOW AVERAGE
- 2 RED LIGHTS
REPLACE BATTERIES - 1 RED LIGHT
Fig. 10
Fig. 9
