Helpline No. UK/Northern Ireland 0800 328 6020
Rep. Ireland 00800 4467 5888
E-mail Support [email protected]
Model Number: GT-8000, GT-FSI-05 / GT-FSI-05d
16
Helpline No. UK/Northern Ireland 0800 328 6020
Rep. Ireland 00800 4467 5888
E-mail Support [email protected]
Model Number: GT-8000, GT-FSI-05 / GT-FSI-05d
17
press the NEW CODE button in the battery compartment of the
remote control. Then, a new system code is generated. You must
now repeat the allocation procedure for all remote sockets
Note:
Always change the code if you determine irregularities or malfunc-
tions and repeat the allocation. This almost always rectifies all faults
and errors.
If the remote sockets are disconnected from the mains, the are able
to store the set channels and the system code for approx. 1 hour. If
the remain disconnected from the mains for a longer period of time,
they must be reprogrammed after being reconnected.
Please note that a suitable lamp must be connected (according
to the technical values specified on page 11 and 12) for the setup
and operation of the remote socket with dimmer. Otherwise, the
socket will not function and setup (e.g. allocation of the channel)
will not be possible.
The remote control is equipped with four channels. You can allocate
a dedicated channel to each remote socket, or you can use one
channel for several remote sockets, in order to switch them on/off
at the same time.
In order to allocate a channel to a remote socket, press the
button on the respective remote socket and keep it pressed. Now
press the button for the channel that you intend to allocate to this
remote socket on the remote control.
As soon as the channel is allocated, the consumer on the relevant
remote socket will be switched on and the control lamp in the
remote socket will illuminate (switch only). On the remote socket
with dimmer, the control lamp will behave as described under
“Display on the remote socket with dimmer”.
In order to check whether the allocation works, press the relevant
button and for the allocated channel.
If the remote socket should not respond, repeat the allocation
process. If overlaps should take place with other remote sockets,
or similar, in your household, use a sharp object (pen or similar) to
Allocation of the channels to the
remote sockets
Allocation of the channels to the
remote sockets
