Helpline No. UK/Northern Ireland 0800 328 6020
Rep. Ireland 00800 4467 5888
E-mail Support [email protected]
Model Number: GT-8000, GT-FSI-05 / GT-FSI-05d
18
Helpline No. UK/Northern Ireland 0800 328 6020
Rep. Ireland 00800 4467 5888
E-mail Support [email protected]
Model Number: GT-8000, GT-FSI-05 / GT-FSI-05d
19
Directly to the remote socket without
dimmer
If you press the button the remote socket briefly, the plugged-in
consumer will be switched on/off.
With the
button, you can allocate the remote socket to a
new channel at any time, see "Allocating the channels to the remote
sockets".
Directly to the remote socket with dimmer
If you press the button the remote socket briefly, the plugged-in
consumer will be switched on/off.
If you keep the button
the remote socket pressed, the dim-
mer will slowly start to darken the lamps, until the go out, and
subsequently brightens them, until there are fully lit. It repeats this
process, until you release the switch.
If you release the switch and then press it in again, the dimmer will
control the brightness in the other direction.
With the
button, you can allocate the remote socket to a
new channel, see "Allocating the channels to the remote sockets".
Operation
About the remote control (GT-8000)
Switching on and off
To switch a consumer on/off, press the relevant / button of the
channel (1, 2, 3 or 4, depending on the allocation).
With the
button, all channels are switched on. With the
button, all channels are switched off.
Dimming lights
In order to use the dimming function, the relevant channel needs to
be activated for the remote socket with dimmer. A channel is always
activated when the relevant - or button has been pressed on
the remote control.
Now, press the
button, in order to reduce the brightness
increase the brightness.
If you activate all channels with the
- or
switch, both
dimmers are controlled simultaneously using the
bzw.
buttons.
If you place both remote sockets with dimmer on the same channel,
both dimmers can only be controlled at the same time.
Note:
After a power failure, a malfunction of the memory for the system
code and the channel of the remote socket could take place in rare
cases. In this case, disconnect the remote socket from the mains for
at least 6 hours and then carry out the allocation procedure again.
Operation
