1
Connect base bracket (F), bottom poles (D) and base stand (E)
as shown using long bolts (G, J) Nuts (K) and Washers (L).
Do not tighten bolts until rack is fully assembled and tubes are
properly aligned. Fully assemble base before continuing.
3
5
Connect top poles (B)
to center poles (C),
secure with short bolts (I).
Connect top connector (A)
to top poles (B) using
long bolts (G).
4
2
Connect center poles (C) to bottom poles (D),
secure with short bolts (I).
Adjust position of arms before
placing bike on stand.
Tighten all bolts, using
the wrench to hold nuts
where needed.
O Rings (M) are included
toto slide over the base
legs to ensure balance
on uneven floors (Figure 1)
IMPORTANT / SAFETY
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
© Copyright 2020
After rack is assembled
Arms should be placed at
desired height - two per
bike (front and rear).
Front side of rack features the
longer section of the base foot
Need help?
Please do not return to store.
For immediate response email [email protected]
Always load bikes on the arms of the bottom,
front side of the rack first to maintain stability.
Remove bikes from the top first.
Ebike storage on lower tier only.
Do not allow children to play or hang from rack.
FIGURE 1
