DFM-400P Rev 2.1 Installation and Appplication Guide Edition 1.6
Page 13 of 14
Cautions and Warnings
WARNING
The DFM-400P Field Module is an Electro-statically sensitive device. Proper ESD
protection (ground strap) should be used when installing this product so that damage to the
product does not occur.
Compliance Declarations
FCC Compliance Information
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Industry Canada Compliance Statement
ICES-003 This Class A digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la Classe A Respecte toutes les exigences du Règlement sur
le matérial brouiller du Canada.
UL Compliance Information
This product conforms to the following UL requirements:
•
UL916: Energy Management Equipment
•
CAUTION – Risk of Electric Shock – More than one disconnect switch may
be required to de-energize the equipment before servicing
•
AVERTISSEMENT – Risque d'électrocution. Plus d'un interrupteur général
peut être requis pour mettre l'équipement hors tension avant de procéder
à son entretien
•
All terminals are acceptable for Class 2 circuit connection only
•
CAUTION – Input Class 2 Power Supplies are interconnected. To Reduce
the Risk of Fire or Electric Shock, Use only Class 2 sources Suitable for
Interconnection
•
AVERTISSEMENT – Les alimentations de classe 2 sont interconnectées.
Pour réduire le risque d'incendie ou de décharge électrique, n'utiliser
qu'une source d'alimentation de classe 2 adaptée
•
Use Copper Conductor Only
•
Select an external power supply that is certified for safety for the correct
destination country and that has an output rating, which is considered an
NEC Class 2 or Limited Power Source with the rating not to exceed 30 V
rms, 42.4 V peak, 100 VA.
•
Apply minimum 6.0 lb-in torque for tightening field wires into the terminal
blocks.
