Delta DelREMO-V2.0, Руководство пользователя

Страница: 17 / 45

•
17
4.1.3 System Configuration
After DelREMO-V2.0 is powered ON, connect the DelREMO to Laptop/PC via Ethernet port provided at the
bottom of unit using RJ45 cable. Following settings are to be done on Laptop/PC to access the DelREMO:
-
I. Click on Start TAB , and then go to Control Panel TAB as Shown below.
II. After Clicking on Control Panel, window will appear as shown, click on Network and sharing
Center .
III. After Clicking on Network and sharing Center, window will appear as shown, click on Change
adapter settings .
IV. After clicking on change adapter settings, the window will appear as shown; right click on the icon
“
Local area connection
” as shown below.
V. Now click on properties as highlighted.
VI. After clicking Properties window will appear as shown, select Internet Protocol Version 4
(TCP/IPv4), then clicks on properties (highlighted in yellow).
VII. After clicking on properties window will appear as below and select
“
Use the following IP
address
”. Now do setting as provided in below snapshot, after doing setting click on
OK Tab.
IP Address : 192.168.100.1
Subnet Mask : 255.255.255.0
1
Check input supply to adapter is
switched ON.
2
Check for output 24VDC voltage at the
output of adapter.
3
Check for LED operation of DelREMO-
V2.0