2
3
5. Pull the wire through the hole and into the junction
box(not included), secure 120VAC house wiring
from the wiring diagram on page 1. 14AWG is the
smallest conductor that shall be used for branch-
circuit wiring.
Push the wires back through the hole. Reattach the
wiring box cover.
❶
5
6. Install a circular 3 in. duct (not included) and secure
it with duct tape or clamps (neither included).
Mount the Fan Body
1
to the joist or stud using
nails (not included) were indicated.
Joist or wall stud
Tape
3 inch duct
Nail
❶
6
7. Plug the fan connector and fan assembly back into
the Fan Body
1
. Reattach the fan assembly using
the three screws removed in step 4.
7
GRILLE INSTALLATION
1. Pinch the mounting springs on the Grille
2
, and
insert them into the narrow rectangular slots inside
the fan. Push the Grille
2
up toward the ceiling.
Turn on electricity at the breaker box after finishing
installation.
1
OPERATION
1. Fan On:
Flip wall switch to “ON” position.
2. Fan Off:
Move wall on/off switch to “OFF” position.
CARE AND MAINTENANCE
See safety information before proceeding. Routine
maintenance should be done at least once a year.
• Never use solvents, thinner or harsh chemicals
when cleaning the fan.
• Do not allow water to enter the motor.
• Do not immerse metal parts in water.
• Do not immerse resin parts in water over 140º
Fahrenheit.
Turn off power source. Review all safety precautions
1. To remove grille
2
, squeeze springs and pull down.
2
1
2. Wash and clean the grille
2
in a sink and dry with a
cloth.
2
2
3. Remove dust and dirt from the fan body
1
with a
vacuum cleaner.
1
Vacuum
cleaner
3
4. Dampen cloth with dust detergent and wipe the fan
body
1
. Then wipe dry with a clean cloth.
1
4
5. Replace grille
2
back onto fan body
1
.
2
1
5
6. Turn on power source to operate fan again.
