2
PACKAGE CONTENTS
PART DESCRIPTION
APPEARANCE
QTY
1
Fan Body
1
2
Grille
1
3
Duct Connector
1
ASSEMBLY INSTRUCTIONS
NEW CONSTRUCTION
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Attach the Duct Connector
3
to the Fan Body
1
❶
1
2. Remove the wiring box cover from the Fan Body
1
.
Remove the wiring knockout from the wiring box
cover with a flathead screwdriver (not included).
❶
2
3. Place the Fan Body
1
next to a ceiling joist or
wall stud. The Fan Body
1
should be level and
perpendicular to the joust or stud.
Joist or
wall stud
❶
3
4. Mount the Fan Body
1
to the joist or stud using
nails (not included) were indicated.
❶
Joist or wall stud
Nail
Nail
4
5. Pull the wire through the hole and into the junction
box(not included), secure 120VAC house wiring
from the wiring diagram on page 1. 14AWG is the
smallest conductor that shall be used for branch-
circuit wiring.
Push the wires back through the hole. Reattach the
wiring box cover.
❶
5
6. Install a circular 3 in. duct (not included) and secure
it with duct tape or clamps (neither included).
Finish ceiling work. The ceiling hole should be
aligned with the edge of the fan housing.
Ceiling
3 in. Duct
Duct tape
or clamp
6
EXISTING CONSTRUCTION
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Remove existing fan.
1
2. Measure the opening to ensure it is large enough to
accommodate the new Fan Body (7 1/2 in. x 7 1/4
in.).
Note: 7 1/4 inch side of opening should be flush with
the joist.
2
3. If this fan is not replacing an old fan, be sure to cut
a 7 1/2 in. x 7 1/4 in. opening for the Fan Body
1
.
Make sure the 7 1/4 inch side of opening is flush
with the joist for installation from below.
7
1/2
in.
7
1/4
in.
3
4. Attach the Duct Connector
3
to the Fan body.
Remove the wiring box cover from the Fan Body
1
.
Remove the wiring knockout from the wiring box
cover with a flathead screwdriver (not included).
Remove the three screws that hold the fan motor
assembly in place. Remove the fan motor assembly
from the Fan Body
1
. Unplug fan connector.
❶
4
