Delta 81HM003J24, Инструкция по эксплуатации

Страница: 18 / 32

12
Caution!
When the pipe is properly protected, do not bend it to a very small angle; otherwise the pipe
might crack or broken.
3). Wrap the pipe with tapes.
(1). Use the adhesive tape to wrap the connecting pipe and cable into one bundle. To prevent
condensate water from overflowing out of the drainpipe, the drainpipe shall be separated
from connecting pipe and cable.
(2). Wrap the heat preservation tape so that each ring of tape shall press half of the previous
ring.
(3). Fix the wrapped pipe onto the wall with pipe clamp.
Caution!
① .
Do not wrap the protective tape too tightly, as this will decrease the heat insulation
performance. Ensure that the drain hose of condensate water is separated.
② .
After completing the protection work and wrapping the pipe properly, close the wall holes
with sealing materials.
5. Connection of Communication Line for Indoor Unit and Outdoor Unit
Open the electrical box of indoor unit and outdoor unit. Insert the distribution line
(communication line) into electrical box via cable hole. Be sure to connect the indoor unit and
outdoor unit in accordance with the wiring diagram labeled on the unit. (Refer to the electrical wiring
of indoor unit and outdoor unit). The specification of power cable shall be selected in reference to
the power capacity and installation environment of the unit. If no error, press wire clip respectively
onto the cables tightly and then reinstall the electrical box cover. Magnetic rings shall be installed
on two ends of the communication line.
Connect communication wire of indoor and outdoor unit by the following
Outdoor unit
CN10
Terminal board Terminal board Terminal board Terminal board
Indoor unit A Indoor unit B Indoor unit N
Wiring
（
resistance matching
）
Power supply
208-230V~ 60Hz
Power supply
208-230V~ 60Hz
Power supply
208-230V~ 60Hz
Power supply
208-230V~ 60Hz