8
C O N N E C T I N G AIR C L E A N E R TO P O W E R S O U R C E
P O W E R C O N N E C T I O N S
A separate electrical circuit should be used for your tools.This circuit should not be less than #12 wire and
should be protected with a 20 Amp fuse. Have a certified electrician replace or repair a worn cord immedi-
ately.Before connecting the motor to a power line, make sure the switch is in the OFF position and be sure
that the electric current is of the same characteristics as stamped on the motor nameplate. Running on low
voltage will damage the motor.
M O TO R SPECIFICATIONS
Your Air Cleaner is wired for 110-120 volt, 60 Hz alternating current. Before connecting the Air Cleaner to the
power source, make sure the switch is in the OFF position. The 1050 RPM motor quietly circulates 850
cubic feet of air per mnute.
Fig. 9
Fig. 8
GROUNDED OUTLET B O X
C U R R E N T
C A R RYING
P R O N G S
GROUNDING BLADE IS
L O N G E S T OF THE 3 BLADES
GROUNDING MEANS
A D A P T E R
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped
with an electric cord having an equipment-grounding con-
ductor and a grounding plug. The plug must be plugged
into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordi-
nances.
Do not modify the plug provided - if it will not fit the out-
let, have the proper outlet installed by a qualified electri-
cian.
Improper connection of the equipment-grounding con-
ductor can result in risk of electric shock. The conductor
with insulation having an outer surface that is green with
or without yellow stripes is the equipment-grounding con-
ductor. If repair or replacement of the electric cord or plug
is necessary, do not connect the equipment grounding
conductor to a live terminal.
Check with a qualified electrician or service personnel if
the grounding instructions are not completely under-
stood, or if in doubt as to whether the tool is properly
grounded.
GROUNDING INSTRUCTIONS
CAUTION: THIS TO O L MUST BE GROUNDED WHILE IN USE
TO PROTECT THE OPERATOR FROM ELECTRIC SHOCK.
Use only 3-wire extension cords that have 3-prong
grounding type plugs and 3-hole receptacles that accept
the tool’s plug, as shown in Fig. 8.
Repair or replace damaged or worn cord immediately.
This tool is intended for use on a circuit that has an out-
let and a plug that looks like the one shown in Fig. 8.
A temporary adapter, which looks like the adapter illus-
trated in Fig. 9, may be used to connect this plug to a
2-pole receptacle, as shown in Fig. 9, if a properly
grounded outlet is not available. The temporary adapter
should be used only until a properly grounded outlet can
be installed by a qualified electrician. THIS ADAPTER IS
NOT APPLICABLE IN CANADA.
The green-colored
rigid ear, lug, and the like, extending from the adapter
must be connected to a permanent ground, such as a
properly grounded outlet box, as shown in Fig. 9.
CAUTION: IN ALL CASES, MAKE CERTAIN THE RE-
C E P TACLE IN QUESTION IS PROPERLY G R O U N D E D .
IF YOU ARE NOT SURE HAVE A CERTIFIED ELEC-
TRICIAN CHECK THE RECEPTACLE.
GROUNDED OUTLET B O X
