9
FASTENING SHAPER TO
SUPPORTING SURFACE
IF DURING OPERATION THERE IS ANY TENDENCY
FOR THE SHAPER TO TIP OVER, SLIDE OR WALK
ON THE SUPPORTING SURFACE, THE SHAPER
MUST BE SECURED TO THE SUPPORTING
SURFACE. HOLES (A) FIG. 16, ARE PROVIDED IN
THE SHAPER LEGS FOR MOUNTING.
Fig. 16
OPERATING CONTROLS AND ADJUSTMENTS
RAISING AND
LOWERING SPINDLE
The spindle can be raised or lowered by loosening lock
knob (A) Fig. 18, and rotating handwheel (B). Rotating
the handwheel clockwise will raise the spindle and
rotating it counterclockwise will lower the spindle.
IMPORTANT:
Final height setting of the cutter should
always be made by moving the spindle upward. Always
tighten lock knob (A) after adjusting spindle height.
Fig. 18
START/STOP SWITCH
The start/stop switch (A) Fig. 19, is mounted on top of
the switch arm for easy accessibility. To start the
machine move the switch (A) to the up "ON" position
and to stop the machine move the switch (A) to the
down "OFF" position.
Fig. 19
LOCKING SWITCH
IN THE "OFF" POSITION
IMPORTANT:
When the tool is not in use, the switch
should be locked in the OFF position using a padlock (A)
Fig. 20, with a 3/16" diameter shackle to prevent
unauthorized use.
Fig. 20
A
B
A
B
A
A