6
UNPACKING
The shaper is shipped with the motor assembly, spindle
and belt assembled to the underside of the table.
Place the shaper table and motor assembly upside
down on a suitable surface, such as two saw horses,
making certain there is clearance for the spindle (A).
IMPORTANT:
The spindle assembly is double-sided,
with a 1/2 inch diameter spindle on one end and a 3/4
inch diameter spindle on the other end. The shaper ¡s
shipped with the 1/2 inch diameter spindle in the
operating position. if you desire to use the 3/4 inch
diameter spindle, refer to section
"CHANGING
SPINDLES AND REPLACING BELTS."
Fig. 2
ASSEMBLY INSTRUCTIONS
ASSEMBLING STAND
1.
Assemble the four legs (E) Fig. 3, to bottom of table.
Align the hole in the bottom of the leg with the hole in the
bottom of table. Place a 7/16" flat washer onto a 7/16-
14x1" hex head screw (F) Fig. 3, insert the screw through
the hole in the leg, and thread the screw into the hole in
the bottom of the table. Repeat this process for the three
remaining legs.
NOTE:
End of leg that has two square
holes (G) and one round hole (H) is to be fastened to
bottom of table, as shown.
Do not completely tighten
hardware at this time.
Fig. 3
Fig. 4
Fig. 5
2.
Assemble back panel (T) and two side panels (U) to
the inside of the four legs, as shown in Fig. 4. Align the
holes in the back panel and the side panels, with the
holes in the legs. Insert a 5/16-18x5/8" carriage head
bolt through the hole in the leg and the hole in the panel.
Place a 5/16" flat washer onto the carriage head bolt,
place a 5/16" lock washer onto the carriage head bolt,
thread a 5/16-18 hex nut onto the carriage head bolt and
tighten securely. Repeat this process for the 11
remaining holes in the panels and legs.
NOTE: Firmly
tighten all leg and panel mounting hardware.
3.
Place the front panel so the label is facing you in the
upright position. Assemble latch assembly to the right
side of the front panel by inserting threaded end of stud
(V) Fig. 5, through hole (W), place rubber bushing (X) on
threaded stud, thread special nut (Y) onto stud.
A
E
F
G
H
E
W
X
Y
V
U
U
T