7
Fig. 6
Fig. 8
Fig. 7
Fig. 9
Fig. 10
4.
Assemble 3/8" rubber grommet (Z) Fig. 6, to round
hole (A) in leg.
5.
Assemble front panel (B) Fig. 7, to the outside of the
two front legs. Insert a 5/16-18x5/8"" carriage head bolt
(C) Figs. 6 and 7, through the hole in the front panel and
the hole in rubber grommet (Z) Fig. 6. Place a 5/16" fIat
washer (D) Fig 6, on the carriage head bolt, and thread a
5/16-18 lock nut (E) Fig. 6, on the carriage head bolt and
tighten the lock nut just enough, for the nut to start to
compress the rubber grommet (Z).
6.
Lift up latch (F) Fig. 7, insert stud on inside of latch
into round hole in leg (G), and press down to lock latch
(F).
NOTE:
If the rubber bushing of the latch will not line up
with the hole in the leg it will be necessary to loosen the
one 7/16-14x1" hex head screw attaching the leg to the
bottom of the table, and repositioning the leg so that the
hole in the leg and the stud on the latch will line up.
NOTE:
The special nut on the latch should be tightened
to a point that it will compresses the bushing just
enough so that the bushing will pass through the hole in
the leg.
7.
Assemble bottom shelf (G) Fig. 8 to the four legs (H)
(one of which is shown). Align the eight holes in the legs
with the eight holes in the shelf. Insert a 5/16-18x5/8"
carriage head bolt through the hole in the leg and the
hole in the shelf. Place a 5/16" flat washer onto the
carriage head bolt, place a 5/16" lock washer onto the
carriage head bolt, thread a 5/16-18 hex nut onto the
carriage head bolt and tighten securely. Repeat this
process for the seven remaining holes.
ASSEMBLING
SWITCH ARM
1. Place a 3/8" flat washer on a 5/16-18x1-3/4" hex
head screw (C) Fig. 9, and insert screw (C) through hole
in bottom of switch arm (D), as shown.
2. Fasten switch arm (D) Fig. 9, to bracket (A) by insert-
ing screw (C) through hole (G) and fasten in place with a
5/16-18 hex nut.
NOTE:
Switch arm (D) will be mounted
in the horizontal position, as shown in Fig. 10, and pro-
trusion (E) Fig. 9, on switch arm will be in hole (F) Fig. 9,
of switch plate. See section
CHANGING POSITION OF
SWITCH ARM
for instructions on moving arm to the
vertical position.
3. Turn shaper right side up.
C
D
E
A
Z
F
G
B
C
G
H
A
G
D
C
E
F
D