13
Fence Controls and Adjustments
DISCONNECT TOOL FROM POWER SOURCE.
Figure 24
The fence halves (A) should be adjusted so that the opening
at the spindle is no more than is required to clear the cutter.
To adjust the fence halves, loosen indexable locking levers
(B) and slide fence halves to the required position. Tighten
locking levers.
Figure 25
Each fence half can be moved independently, forward or
backward, depending on the shaping operation. To move
the fence halves in or out, loosen one of the fence
adjustment allen screw (A). Turn one of the adjusting knobs
(B) to the correct setting. Tighten allen screw (A).
Each fence half can be adjusted for parallelism to the miter
gauge slot. If an adjustment must be made, loosen nuts
(C) and with supplied allen key make necessary correction.
When parallelism is achieved, tighten nuts (C).
Fig. 24
Fig. 25
