9
UNPACKING
FENCE ASSEMBLY
1. Attach the fence support bracket (A) to the tool
frame using two M8 x 25mm socket head screws
(B), each fitted with an 8mm lock washer. See
Figure 1. Ensure that the top surface of the bracket
is flush with the top of the table.
2. Referring to Figure 2, slide the dovetail clamp (C)
onto the fence support (D) ensuring the tops of both
bottom pins in the clamp are flush with the bottom
surface of the fence support bracket. Loosely
secure the dovetail clamp to the fence support with
the indexing lock handle (E).
3. Attach the fence mounting plate (A) to the fence
(B) using four M8 x 25mm socket head screws and
8mm lock washers. See Figure 3.
4. Slide assembled fence (A) over the fence support
bracket (B). The left edge of the fence assembly
should be aligned with the left edge of the
bracket. The dovetail edge on the right side must
be engaged with the dovetail clamp. Tighten the
indexing lock handle to firmly secure and square the
assembly. Insure that the red sliding guard moves
freely and attaches to the magnets on the rear side
of the fence. See Figure 4.
FIGURE 1
ASSEMBLY
FIGURE 2
Remove any protective materials and coatings from all of the parts and the tool. The protective coatings can be
removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before
all of the protective coatings are removed completely.
If any parts are missing, do not attempt to plug in the power cord and turn “ON” the machine. The
machine should only be turned “ON” after all the parts have been obtained and installed correctly.
FIGURE 3
FIGURE 4
