Delta 36-477, Инструкция по эксплуатации, Страница: 46 / 53

46
LUBRICATION
1. Apply paste wax to fence and guide tube sliding sur-
faces weekly. Also, saw table and extension table surface
should be waxed often.
2. Apply grease to cam lock (A) Fig. 149, and cam foot
(B) occasionally to prevent wear.
ADJUSTING CLAMPING ACTION OF FENCE
LOCKING HANDLE
When the fence locking handle (A) is pushed to the down position, as shown in Fig. 147, the fence assembly (B) should
be completely clamped to the guide tube (C). If the fence assembly (B) is not completely clamped to the guide tube (C)
when the handle (A) is pushed down, as shown in Fig. 147, lift up handle (A) and raise fence assembly (B) up off the
guide tube (C). Slightly tighten the two adjusting screws (D) and (E) Fig. 148, using the 3/16 allen wrench (F) not sup-
plied.
Adjusting screws (D) and (E) Fig. 148, should be tightened an equal amount . Replace fence onto the guide
tube and re-check to see if the fence assembly (B) Fig. 147, is completely tightened to the guide tube (C) with the lock-
ing handle (A) pushed down. Adjust further if necessary.
IMPORTANT: AFTER ADJUSTING THE CLAMPING ACTION
OF THE FENCE LOCKING HANDLE, CHECK TO SEE IF THE FENCE IS PARALLEL TO THE MITER GAGE SLOT
AND ADJUST IF NECESSARY
.
Fig. 146
Fig. 147
Fig. 148
F
D
E
B
C
A
D
E
F
Fig. 149