Delta 36-477, Инструкция по эксплуатации, Страница: 28 / 53

28
Fig. 87
11. After the holes have been drilled in the edge of the front and rear extension
table board, fasten both front and rear rail to table using the 1-1/2 flat head
Phillips screws (T) Fig. 87, 1-1/4 O.D. flat washers (U) and hex nuts (V).
NOTE:
The 1-1/4 flat washer cannot be used on the end holes (X).
12. Lay the guide tube (B) Fig. 88, on the saw table as
shown, and line up the threaded holes (C) on bottom of
guide tube (B) with the through holes (D) on the front rail
(A) in seven places.
13. Position the guide tube (B) Figs. 89 on the front rail
and fasten the guide tube to the rail using the 1/2 long
hex screws (G) and lockwashers in seven places.
Fig. 88
Fig. 89
B
G
B
A
C
D
T
U
V
X