Delta 36-477, Инструкция по эксплуатации, Страница: 41 / 53

41
Fig. 128
Fig. 127
Fig. 129
Fig. 130
If the ripped work is less than 4 inches wide, a push stick
should always be used to complete the feed, as shown
in Fig. 126. The push stick can easily be made from
scrap material as explained in the section
“CON-
STRUCTING PUSH STICK.” When ripping stock 2 inch-
es or narrower, assemble an auxiliary wood facing to the
fence, as explained in the section
“USING AUXILIARY
WOOD FACING ON THE UNIFENCE” and use a push
stick.
When ripping material with a veneer facing that extends
over the material, the fence (A) should be in the horizon-
tal position with the veneer (B) extending over the lip of
the fence, as shown in Fig. 127.
When ripping material with a veneer facing and the
material is not thick enough for the veneer to extend
over the lip of the fence or if the veneer facing (B) is on
both sides of the material, as shown in Fig. 128, the
fence can be positioned slightly above the surface of the
table. The veneer can be placed between the fence and
the table or the veneer can straddle the fence with the
material solidly against the fence, as shown.
RIPPING ON LEFT
SIDE OF SAW BLADE
In some cases it may be desirable to use the fence on
the left side of the saw blade. This is easily accom-
plished by repositioning the fence (A) Figs. 129 and 130,
fence clamp bar (B), and lock knobs (C) so that the fence
(A) will be attached to the right side of the fence body, as
shown in Fig. 130. The complete fence assembly (D)
Fig. 130, can easily be moved to the left side of the saw
table.
Fig. 126
B
A
B
B
A
C
C
A
D