Delta 3 H.P. SINGLE-STAGE DUST COLLECTOR 50-852, Инструкция по эксплуатации

Страница: 11 / 16

11
Fig. 29
Fig. 30
Fig. 31
ASSEMBLING DUST INTAKE
PORT TO BLOWER AND
MOTOR ASSEMBLY
M A K E C E R TA I N T H E D U S T C O L L E C T O R I S
DISCONNECTED FROM THE POWER SOURCE
.
1. Align the four holes in the dust intake port (A) Fig.
29, with the mounting holes in the lip of flange (B) of
blower assembly and fasten with four sheet metal
screws (C).
2. Fig. 30, illustrates the dust intake ports assembled
to the blower assembly.
3. Four dust intake port caps (D) Fig. 31, are supplied
with the dust collector. These caps should be installed to
cover any unused intake ports or when the dust
collector is not in use.
WARNING: DO NOT INSERT FINGERS INTO THE
INTAKE PORTS WHEN UNIT IS OPERATING.
CONNECTING MACHINE TO POWER SOURCE
ELECTRICAL CONNECTIONS
The motor rating of your dust collector is either 230/460 Volt, Three Phase; or 230 Volt, Single Phase. Before
connecting the motor to the power line, make sure the switch is in the “OFF” position and be sure that the electric
current is of the same characteristics as indicated on the tool. All line connections should make good contact.
Running on low voltage will damage the motor.
WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE
TO PROTECT THE OPERATOR FROM ELECTRIC SHOCK.
C
B
A
D