26
Brief instructions:
① .
Pull out the 2-core signal line from the mounting hole and pass this line through the round
hole located at the bottom of the wired controller.
② .
Use M4×25 screws to
fix the soleplate of the wired controller on the wall.
③ .
Fix the signal line on the copper tabs X1 and X2. Make sure the line is tightly fixed and with
no short-circuit potential
.
④ .
Set the panel and the bottom together by clasps.
4.4 How to Remove the Wired Controller
The wired controller can be easily removed as shown in Fig.28
Fig.28 Removal of the Wired Controller
5 Error Display
When error happens to the unit, the error code will be shown on the wired controller. When
multiple errors simultaneously happen, the error codes will circularly show up.
When error occurs, please immediately shut down the unit and contact professional personnel.
As shown in the Fig.29 means the high pressure protection.
Fig.29
