Delta 21CK018C24, Инструкция по эксплуатации

Страница: 46 / 64

45
●
Wiring of unit and the controller
1. Wiring of the indoor unit.
Remove the control box lid, pull the wires inside through rubber bush and wiring according to the
WIRING DIAGRAM , then tighten it with clamp.
2. Wiring of the controller
1) Remove the control box lid, pull wires inside through rubber bush and connect to the controller.
2) Wrap the wire with sealing pad.
3) After wiring, tighten it with clamp and fix the control box lid.
4) Connect the rubber wireto the power supply terminal board in properly.
●
Precautions: Be sure to connect the indoor unit and outdoor unit at right poles.
12.3 Installation of panel
●
Set the panel to the indoor unit body by matching the position of the swing flap motor of the
decoration panel to the piping position of the indoor unit as shown in fig.4.
●
.Install the decoration panel
1 、 Hang the latch, which is located on the opposite side of the swing flap motor on the panel,
temporarily to the hook of the indoor unit. (2 Positions)
2 、 Temporarily hang the remaining 2 latches to the hooks on the sides of the indoor unit.(be careful not
to let the swing motor lead wire get caught in the sealing material.)