DELTA-SPORT 285746, Инструкция по эксплуатации

Страница: 14 / 66

16
Removing the storage battery
1. Disconnect the storage battery plug connection
(3a) and the quadrocopter plug connection
(1a).
2. Remove the storage battery cover (1c) from the
storage battery compartment (1b).
3. Remove the storage battery (3) from the
storage battery compartment (1c).
Suitable flying surroundings
Surroundings for an optimal flight should fulfil the
following criteria:
• Windless, enclosed area.
• People must maintain a safety distance of 5m
from the quadrocopter at the start.
• There must not be any devices in the vicinity
such as air-conditioners, fans, etc. that could
create airflow.
• Pay close attention to the surroundings in which
you are using the quadrocopter.
• The space should have no obstacles (e.g. no
lamps etc.)
• A minimum space size of approx. 10 x 6 x 3m
(L x W x H) is required.
• Look for a large, open, and wide area without
obstacles, paying particular attention to
buildings, groups of people, high voltage lines,
and trees.
• There should be 10m of space on all sides to
perform aerobatics such as loop the loops.
• Make sure the surroundings are dry and free
of precipitation.
• The suitable operating temperature is 10° to
45°.
• Avoid the forbidden areas at all times (you can
find these in the section ‘Safety notes’).
Flight preparation
Pay attention to the following before beginning to
fly the quadrocopter:
1. To start always place the quadrocopter (1) on
a level surface.
2. Always move the throttle (2d) and the joystick
(2e) slowly, carefully, and gently.
3. Always watch the quadrocopter during the
flight
Note: Always keep the quadrocopter in sight
while flying it!
4. Do not hang loads on the quadrocopter.
Starting to fly
Here are a few tips on steering the quadrocopter
before you start to fly:
• Move the throttle (2d) backwards slightly as
soon as the quadrocopter (1) lifts off.
• Move the throttle (2d) forwards slightly if the
quadrocopter (1) dips.
• Tap the joystick (2e) very gently in the desired
direction in order to fly in a curve.
Note: Always switch the remote control on first.
Make sure that the throttle is at the lowest setting
(motor off) when you switch the remote control on!
Only then can the storage battery for the model
be connected. Otherwise the product may react
unpredictably and the rotors could start unintenti-
onally!
Please note that the throttle (2d) goes back to its
original position when you let it go.
1. Press the on and off button (2a) on the remote
control (2) (fig. H). The control lamp (2j) will
flash.
2. Connect the storage battery plug connection
(3a) to the quadrocopter plug connection (1a)
(fig. H).
3. The LED position lamps (1b) on the
quadrocopter (1) will light and a signal will
sound from the remote control (2).
4. Push the throttle (2d) all the way forwards and
then all the way backwards (fig. I).
Note: This process establishes contact between
the quadrocopter and the remote control. If the
throttle is not first moved forwards and then back-
wards the quadrocopter will remain secured and
will not be ready to fly.
5. Signal tones will sound from the remote control
(2). The LED position lamps (1b) on the quadro-
copter (1) will light constantly. The quadro-
copter is now ready to fly (figure I).
Steering the quadrocopter
You have different steering options:
GB