Delta OHM HD40.1, Руководство пользователя, Страница: 19 / 28

- - 19
C) How to configure the instrument
In the instrument you must set:
• baud rate at 38400
• Printing interval.
•
Interface on PRINTER (For a few instruments only , ex. sound level meters).
Important note : the printer baud rate and that of the instrument must be the same,
otherwise the printer doesn’t work.
For further details, please look at the instrument manual.
D) How to connect the instrument to the printer
Connect the printer to the instrument through the serial cable.
•
For instruments with 8-pole MiniDIN connector, use the HD2110CSNM cable: 9-
pole D Sub female – 8-pole MiniDIN (other side).
•
For instruments with 9-pole D Sub male connector, use the 9CPRS232 cable: 9-
pole D Sub female (both sides).
Now the printer and the instrument are ready and configured correctly.
6.2. BLUETOOTH CONNECTION
For the HD40.2 printer.
Follow A, B, C and D steps in this order.
A) Before starting
5) The printer leaves the factory with partially charged batteries: batteries must
be fully charged before use. Plug the battery charger to the connector located
in the rear of the printer: the POWER led lights to indicate that batteries are on
charge.
6) Wait for the POWER led to turn off: this may take a few hours.
7) Unplug the battery charger.
8) Insert the thermal paper roll as shown in chap. 3.2.
B) How to configure your printer for connection to an instrument with Blue-
tooth interface
The printer leaves the factory with the following settings:
• Interface: RS232
•
Baud Rate: 38400 baud
•
Automatic switch-off delay: 5 minutes
• Printing density: 0.
Please follow the steps below to change these parameters:
• When the printer is off, press the MENU key and the ON/OFF key until the printer
turns on and the paper roll advances. The communication interface parameter
(
RS232 or Bluetooth) will appear.
• Press the MENU key to select the Bluetooth parameter. Press the ON/OFF key to
confirm.