Delta OHM HD40.1, Руководство пользователя, Страница: 11 / 28

- - 11
3.3. BATTERIES
3.3.1. How to charge batteries
Use the SWD10 battery charger supplied with the printer to charge batteries.
Follow the steps below:
•
Connect the battery charger plug to the mains and the battery charger connector
to the socket in the rear of the printer.
•
If batteries are extremely discharged or temperature is too low, the POWER led
blinks for a few seconds (precharge) and then it remains on to indicate printer
quick charge.
• Charge the batteries until the POWER led turns off.
• Now the printer is ready: disconnect the battery charger cable.
Note : The first time you use the printer, you need to fully charge batteries.
3.3.2. Notes on battery usage
•
A new NiMH battery performs best only after fully discharging and charging it at
least twice or three times.
•
Battery autonomy changes significantly depending on printing intensity and quan-
tity. Even a charged battery will eventually discharge if unused.
• The battery may be charged and discharged hundreds of times but the battery will
eventually become exhausted. When autonomy (both when printing and waiting) is
far lower than usual, battery pack needs replacing.
• Use only the BAT-40 Delta Ohm battery pack and charge it by using the SWD10
battery charger, or alternatively, one complying with our technical specifications.
• NiMH batteries last longer provided that you discharge them completely from time
to time.
• Extreme temperatures may negatively affect battery performance.