4
2. Upon first start up
Some notes about
first start up
are reported below. For the details see the various chapters
in the manual.
Before
turning on, the probe should be connected to the instrument.
Apply the correct voltage to the instrument. A wrong voltage can cause permanent damages
to the instrument that are not covered by the warranty.
In order to install and connect the instrument, please see the chapters “
Installation and
connection
” and “
Terminal board
description
”.
To use the analog outputs and relays, please see the chapters “
Current and voltage analog
outputs
” and “
Instruments fitted with relay outputs
”, respectively.
For the connection to a PC or network of instruments, please see the charter “
Serial
communication and instrument network
”.
Check the instrument date and time as described in the following chapter.
3. Initial setting or date and time update
When you power up the instrument, the date and time check takes about one minute.
The following screen will appear:
2008/01/01 12:00:00
TIME/DATE
year/mm/dd hh:mm
2008/01/01 12:00:00
<UP> <DOWN> change
<ENTER> confirm
<ESC> exit
The date and time are correct: press MENU to go directly to measurement mode.
The date and time are not correct:
1. Use the
arrows to modify the year, already selected, and press ENTER.
2. You will get to the month setting. Change it using the
and
arrows and confirm
with ENTER.
3. Repeat for the other items: day, hour, minutes. After the last confirmation you will
exit the setting page and return to the menu main screen.
4. Press MENU to return to measurement mode.
For the next date and time setting, please see the “
TIME/DATE
” menu item description in the
chapter “Description of the menu”.
