Delta Heat DHPW22, Инструкция по установке, использованию и уходу

Страница: 19 / 28

Delta Heat Service (562) 263-3600 | 13
OPERATING INSTRUCTIONS
BEFORE LIGHTING THE POWER BURNER
DO NOT ATTEMPT TO LIGHT THE POWER BURNER IF YOU SMELL GAS
• WARNING! IT IS CRITICAL THAT THE GAS BURNER IS PROPERLY INSTALLED WITH
THEIR ORIFICES INSIDE THE BURNERS AIR SHUTTERS. If not properly installed, gas
may leak outside of the burner that could lead to fire, potential damage to your Power
Burner and bodily injury.
• Inspect the gas supply piping or hose prior to turning the gas ON. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to use. The replacement pressure regulator and
hose assembly must be the type specified by the manufacturer. Do not use the Power Burner
if the odor of gas is present. The pressure regulator and hose assembly supplied with the units
must be used.
• If the unit is LP, screw the regulator and hand tighten to the valve of the cylinder and leak check
the hose and regulator connections with a soap and water solution before operating the Power
Burner. Reference page 6 for leak test procedure.
• Always keep your face and body as far away as possible when lighting.
• Refer to spiders and insects warning and procedure under the cleaning and maintenance page
of this manual.
TO LIGHT THE POWER BURNER’S BURNER
1. Open the gas supply shut-off valve.
2. Push in the knob and verify that the igniter sparks. If the igniter does not spark, replace the 9V
battery. (Reference page 7 for electrical requirements).
3. Once sparking is verified, simultaneously push-in and turn the knob counter-clock-wise to the
biggest flame marking on the bezel. Hold the knob pushed in until you see or hear a flame, then
you can release the knobs.
CAUTION: If ignition does not take place within 5 seconds, turn knob to the OFF position, wait for five
minutes and repeat step 3.
MATCH/BBQ LIGHTER LIGHTING INSTRUCTIONS:
The burner can be lit manually using a paper book match with the supplied lighting wand, lighted long
match, taper or BBQ lighter if there is no spark from the spark igniters.
1. Insert a lit match or BBQ lighter through the grates and near the top of the burner. Once you see
or hear a flame you can release the knob.
IMPORTANT:
If burner fails to light within 5 seconds, turn off gas and wait 5 minutes before repeat -
ing the process.
WARNING: If you smell gas, shutoff the gas supply and immediately check for leaks using the soapy
water technique outlined in the Leak Test section (Pg 6).