EN
8
9
1/ Motor fitting
• Never strike the motor head or output shaft to fit the motor into the tube.
Never pierce the tube when the motor is installed.
• To attach the apron, use screws that do not protrude into the tube by more
than 1 mm.
1.1 Crown and wheel assembly
1.2 Mounting in the tube
For mechanical parts and drive and mounting accessories,
consult our catalogue.
Model
Length for drilling (L)
TYMOOV 10Nm et 20 Nm
455 mm
TYMOOV 30 Nm
525 mm
Tube
L: length for drilling wheel
attachment using screws or rivets
1.3 Motor head position
The motor head must be positioned on the support as such that the cable outlet is in
the lower part relative to the horizontal.
1.4 Mounting of the motor onto its support
Push the tube/motor assembly (A) onto the support (B) until it engages (click).
Câble
(A)
(B)
“Click”
Always make a kink in the power cable
to avoid the penetration of water into
the motor.
Screwing into the motor
head is strictly prohibited.
Crown
Motor
head
Wheel
“Click”
Adjusting
screw
