EN
10
11
The electrical wiring must comply with EN, IEC and national institute standards (e.g.
NF C15-100 for France).
In all instances, it must still be possible to switch off the power supply using an
omnipolar device in accordance with the applicable installation requirement. If
the motor is supplied with a H05VVF power cable, this cable cannot be installed
outdoors, unless it is inside a UV-resistant duct.
For outdoor use, the motor must be equipped with a RNF or RRF rubber cable with
at least 2% carbon. Contact the sales department.
Connection with a toggle or biased change-over switch
- A change-over switch prohibiting the simultaneous pressing of
the
or
buttons must be used.
- In the case where a biased change-over switch is used, the user must press and
hold the button throughout the shutter operating time.
You can wire several motors to the same change-over switch, within the maximum
permissible current capacity, however, the adjustment of the stops must be
performed separately.
2/ Connection
3/ Setting stops
You can connect
Tyxia 5630 micromodules to the Tymoov xFB motors.
They must be connected after the setting of the stops.
4 x 0.75 mm²
L
L
N
N
Blue
Neutral
Brown
Phase for rotation or .
Black
Phase for rotation or .
Yellow /
Green
Earth
L
Phase
N
Neutral
Black
Brown
Blue
Note: If the raise and lower directions
are reversed, swap the brown and
black wires (
and
on the change-
over switch).
Power supply
230 V, 50 Hz
Single-phase
Yellow / Green
❶
Identify the type of roller shutter winding
❷
Determine the position of the motor viewed from the outside of the dwelling
❸
Setting the stops
To set the stops, use the adjusting tool or a 4 mm hex
screwdriver.
Exterior
housing
Interior
winding
Exterior
winding
Exterior
housing
Interior
housing
Interior
housing
Left
mounted
motor
Right
mounted
motor
White adjusting
screw
Red adjusting
screw
Red adjusting
screw
White adjusting
screw
Left
mounted
motor
Right
mounted
motor
