DELTA DORE Pack TYMOOV 10, Руководство пользователя, Страница: 9 / 14

EN
16 17
> 3s
> 3s
x 2
x 1
The motor has already been associated with a transmitter.
You can associate various transmitters from the X3D range (telephone transmitter,
other remote control, etc.) with the up/down function of the motor. Number of
transmitters that may be associated: 16 max.
To associate these transmitters, please consult their instructions.
An additional user guide describing the operation of the TYMOOV motor with the
TYXIA 1712 and TYXIA 2330 remote controls is available on the website
www.deltadore.com.
The stops must fi rst be removed then set again for them to be modifi ed.
Remove them by proceeding as follows:
See section 3.2 “setting stops” to set them again.
4/ Modifying stops
5/ Associating another transmitter
> 3s
CR 2430
x 2
The motor
will be activated briefl y.
twice.
Press button B on the front
panel of the remote control,
until the LED fl ashes green.
On the transmitter, press and hold
the
et buttons at
the same time for more than 3
seconds until the LED comes on.
The stops will now be
removed
The new
remote control
will now be
associated with the
motor
On the transmitter that is already
associated, press the
button for more than 3 seconds
until the motor is activated briefl y.
Validate on the transmitter to be
associated (e.g. new remote control)
On the new remote control,
press the
and
buttons at the same time for
more than 3 seconds until the
LED comes on.
The motor will briefl y
be activated twice.
You want to control the opening of roller shutters if smoke is detected
6/ Associating a smoke detector
> 3s
x 2
x 1
On the transmitter that is already
associated, press the
button for more than 3 seconds
until the motor is activated
briefl y.
Briefl y press the button of the
detector.
The motor will briefl y
be activated twice.
When the motors have been associated via a bidirectional grouped command, they
will start up at slightly staggered time intervals (100 ms) in order to limit the peak
current in the electric line during start-up.
• If the motors were associated at the same time in a grouped command, they will
start up in the order in which they were detected during the association process.
E.g. It could be that one lounge motor starts fi rst, followed by a bedroom motor,
then the second lounge motor. There may be a time lapse between the fi rst and
second lounge motors starting.
• If you would like the motors to start in a specifi c order, you should associate them
one by one in the order you require.
Refer to the user guide for each remote control.
E.g. If you have 3 roller shutter motors in one lounge, associate them one by one
with the remote control so that they start up without a big time lapse.
7/ Grouped command