Digital Projection
E-Vision Laser 9000 Series
Rev A December 2019
Page 15
Important Information
Connecting the power supply
Firmly push the mains
connector into the AC IN
socket.
Use only the power cable provided.
Ensure that the power outlet includes a ground connection as this equipment MUST be
earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
Switching the projector on
1. Connect the power cable between the mains supply and the projector. (See
Connecting the
power supply
above.)
2. The
POWER
indicator lights green to indicate that the projector is in STANDBY mode. Press one
of the following buttons:
•
On the remote control, the
ON
button
•
On the projector control panel, the
POWER
button.
The
POWER
indicator begins flashing green and the fans start. The
POWER
indicator lights
steady Green when the projector is fully switched on.
Switching the projector off
1. Press
OFF
on the remote control or
POWER
on the control panel, then press again to confirm
your choice. The
POWER
indicator light will flash green until the cool down period has completed,
then goes steady green to indicate that the projector has entered
STANDBY
mode.
2.
If you need to switch the projector off completely, disconnect the power cable from the projector.
1
1
