DèLonghi ECAM45.760, Инструкция по эксплуатации

Страница: 18 / 25

17
Cleaning the inside of the coffee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned off
(see “Turning off”) and unplugged from the mains power sup-
ply. Never immerse the coffee machine in water.
33
1. Check regularly (about once
a week) that the inside of
the appliance (accessible
after removing the drip
tray) is not dirty. If neces-
sary, remove coffee deposits
with the brush supplied and
a sponge.
2. Remove the residues with a
vacuum cleaner (fig. 33).
Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month
and whenever you replace the water softener filter (if pre-
sent) with a damp cloth and a little mild washing up liquid.
2. Remove the filter (if present) and rinse with running water.
3. Replace the filter (if present), fill the tank with fresh water
and replace the tank.
Cleaning the coffee spouts
34
1. Clean the coffee spouts
regularly with a sponge or
cloth (fig. 34).
2. Check the holes in the cof-
fee spout are not blocked.
If necessary, remove coffee
deposits with a toothpick
(fig. 34).
Cleaning the pre-ground coffee funnel
Check regularly (about once a month ) that the pre-ground cof-
fee funnel (A4) is not blocked.
If necessary, remove coffee deposits with the brush (D2)
supplied.
Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “Turning
off”, page 9).
2. Extract the water tank (fig. 4).
3. Open the infuser door (fig. 35) on the right side of the
appliance.
35 36
PUSH
PU
SH
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (fig. 36).
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (D2) to remove any coffee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 37), then push the PUSH symbol fully
in until it clicks into place.
37
Please note!
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 38.
38
8. Once inserted, make sure the two red buttons have snap-
ped out (fig. 39).
Infuser
support
Small lever
Large lever