DèLonghi ECAM45.760, Инструкция по эксплуатации

Страница: 19 / 25

18
39
PUSH
9. Close the infuser door.
10. Replace the water tank.
Cleaning the milk container
Clean the milk container every two days as described below:
1. Remove the lid.
2. Remove the milk spout and intake tube.
3. Turn the froth adjustment dial clockwise to the “INSERT”
position (fig. 40) and pull off upwards.
40
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dishwasher
safe, placing them in the top basket of the dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 41). If necessary, scrape the
groove with a toothpick.
41 42
5. Rinse inside the froth adjustment dial seat with running
hot water (fig. 42)
6. Check that the intake tube and spout are not clogged with
milk residues.
7. Replace the dial (in correspondence to the word “INSERT”),
spout and milk intake tube.
8. Place the lid back on the milk container.
Cleaning the hot water/steam connection nozzle
Each time you prepare milk, clean the connection nozzle with a
sponge to remove milk residues from the gaskets (fig. 26).
DESCALING
Descale the machine when the message “DESCALE” flashes on
the display.
Important!
• Descaler contains acids which may irritate the skin and
eyes. It is vital to respect the manufacturer’s safety war-
nings given on the descaler pack and the warnings relating
to the procedure to follow in the event of contact with the
skin and eyes.
• You should use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer’s guarantee.
1. Turn the machine on.
2. Press the
MENU/ESC button to enter the menu.
3. Press < or > until “Descale” is displayed.
4. Select by pressing the
OK
button: Confirm? is displayed.
Press the OK button to confirm.
5. “EMPTY THE DRIP TRAY” is displayed, alternating with “RE-
MOVE FILTER” (if the filter is featured) and “ADD DESCALER,
Press OK”.
6. Empty the water tank (A16) completely and remove the
water softener filter (if present). Empty the drip tray (fig.
30) and grounds container, then put them back in the
appliance.
B
A
A B
43
7. Pour the descaler into the
tank up to level A (corre-
sponding to a 100 ml
pack) marked on the back
of the tank (fig. 43), then
add water (1 litre) up to
level
B (fig. 43) and put
the water tank back.
8. Place an empty container
with a minimum capacity
of 1.5 litres under the hot
water spout (fig. 7).
Important! Danger of burns
Hot water containing acid flows out of the hot water spout.