22
18.1 Cleaning the inside of the coffee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned off
(see section “7. Turning the appliance off”) and unplugged from
the mains power supply. Never immerse the coffee machine in
water.
1. Check regularly (about
once a month) that the
inside of the appliance
(accessible after removing
the drip tray, A14) is not
dirty. If necessary, remove
coffee deposits with the
brush (C5) supplied and a
sponge.
2. Remove all the residues
with a vacuum cleaner
(fig. 47).
18.2 Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener filter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the filter (if present) and rinse with running water;
3. Replace the filter (if provided), fill the tank with fresh water
and replace the tank;
4. (Models with water softener filter only) Deliver about
100ml of hot water to reactivate the filter.
18.3 Cleaning the coffee spouts
1. Clean the coffee spouts
(A8) regularly with a
sponge or cloth (fig. 48A);
2. Check that the holes in
the coffee spouts are not
blocked. If necessary, re-
move coffee deposits with
a toothpick (fig. 48B).
18.4 Cleaning the pre-ground coffee funnel
Check regularly (about once a month) that the pre-ground cof-
fee funnel (A4) is not blocked. If necessary, remove coffee depos-
its with the brush (C5) supplied.
18.5 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “7. Turn-
ing the appliance off”);
2. Remove the water tank (A16) (fig. 3);
49
50
PUSH
PUSH
3. Open the infuser door (A18) (fig. 49) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 50);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Clean the infuser without using washing up liquid as it could be
damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support (fig. 51), then push the PUSH symbol fully in
until it clicks into place;
51
52
47
48B
48A
