10
AUto-oFF
Auto-off can be set so that the appliance turns off after 15 or 30
minutes, or after 1, 2 or 3 hours�
To re-set Auto-off, proceed as follows:
1� With the appliance turned off but with the main power
switchpressed down, press the
button and
hold it down until the indicators on the control panel
come on�
2� Press the
button until the indicators corresponding
to the amount of time before the appliance turns off
automatically come on:
15 minutes
eCo
30 minutes
eCo
1 hour
eCo
2 hour
eCo
3 hour
eCo
3� Press the
button to confirm the selection� The
indicators go off�
eneRGY sAVInG
Use this function to enable or disable Energy Saving�
When enabled, the function reduces energy consumption in
compliance with EU regulations�
Energy saving mode is active when the
eCo
indicator is on�
1� With the appliance turned off but with the main power
switch pressed down, press the
button and hold it
down until the
eCo
indicator comes on (fig� 8)�
2� To deactivate this function off, press the
: button
until the
eCo
indicator flashes�
3� To re-activate this function, press the
: button
again: the
eCo
indicator should come on�
4� Press the
button to confirm the selection� The
eCo
indicator goes off�
Please note:
When in energy saving mode, a few seconds may elapse before
the first coffee is delivered as the appliance must heat up
again�
WAteR soFteneR FILteR
Certain models are fitted with a water softener filter� If this
is not the case with your model, you are recommended to
purchase one from authorised De’Longhi Service Centres�
Important:
• Keep in a cool dry place out of direct sunlight.
• After opening the packaging, use the filter at once�
• Remove the filter before descaling the machine�
To use the filter correctly, follow the instructions below�
Installing the filter
1� Remove the filter from the packaging�
2� Turn the date indicator disk until the next two months of
use are displayed (fig 9)�
Please note:
The filter lasts about two months if the appliance is used
normally� If the coffee machine is left unused with the filter
installed, it will last a maximum of three weeks�
3� To activate the filter run tap water into the hole as
indicated in the diagram letting the water run out of the
side openings for at least one minute (fig� 10)�
4� Take out the tank from the appliance and fill with water
(fig� 1A)�
5� Place the filter in the water tank and submerge it
completely, tilting it to enable the air bubbles to escape
(fig� 11)�
6� Insert the filter into the filter housing and press as far as it
will go (fig�12)�
7� Close the tank with the lid (fig� 13), and then replace the
tank in the machine�
8� Place a container with a minimum capacity of 100 ml
under the cappuccino maker�
9� Turn the steam dial to the I position to deliver hot water�
10� Let the machine dispense hot water for a few seconds
until the flow of water is steady, then turn the steam dial
back to the 0 position�
�
Please note:
Occasionally one delivery of hot water is not enough to install
the filter and the following indicators will come on during
installation:
If this happens repeat the installation procedure from point 9�
The filter is now active and you can use the coffee machine�
Removal and replacement of the water softener
filter
After two months (see date indicator disk), or if the appliance
has not been used for 3 weeks, the filter must be removed from
the tank and replaced with a new one� Then the installation
procedure above must be repeated�
MAKInG CoFFee
selecting the coffee strength
Turn the selection dial (B10) to set the required coffee strength�
Turning it clockwise increases the quantity of coffee beans
the appliance will grind and therefore increases the coffee
strength�
