DeLonghi PrimaDonna Elite Experience ECAM65X.85, Инструкция по эксплуатации

Страница: 24 / 37

23
18.7 Cleaning the coffee spouts
1. Clean the coffee spouts (A8)
regularly with a sponge or
cloth (fig. 48A);
2. Check that the holes in
the coffee spouts are not
blocked. If necessary, re-
move coffee deposits with
a toothpick (fig. 48B).
18.8 Cleaning the pre-
ground coffee funnel
Check regularly (about once a
month) that the pre-ground
coffee funnel (A4) is not
blocked. If necessary, remove coffee deposits with the brush (C5)
supplied.
18.9 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “7. Turn-
ing the appliance off”);
2. Remove the water tank (A16) (fig. 3);
3. Open the infuser door (A18) (fig. 49) on the right side of
the appliance;
49 50
PUSH
PUSH
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 50);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Clean the infuser without using washing up liquid as it could be
damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support (fig. 51), then push the PUSH symbol fully in
until it clicks into place;
Please note!
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 52.
51 52
8. Once inserted, make sure
the two coloured buttons
have snapped out (fig. 53);
9. Close the infuser door;
10. Put the water tank back.
18.10 Cleaning
the milk container
To keep the frother efficient,
clean the milk container (D)
every two days as described
below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 54);
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (fig. 54) and pull it off upwards;
54
48B
48A
53
PUSH