17
en
Control panel/ Operation
OPERATION
Turning the appliance on
Please note: Before plugging the appliance
check: the caps on the back of the unit are correctly
inserted and screwed on the drainage hose 10.
Plug the appliance into the mains. Press the
ON/OFF
button
(
A
) (when turned on, the air conditionerstarts operating in
the same mode as when it was turned off). The display shows
the room temperature. Press the
MODE
button (
B
) until the
indicator light correspondingto the required mode lights up:
Light (
O
): air-conditioning mode
Light (
N
): fan mode
Light (
P
): dehumidifying mode
Air-conditioning mode
Ideal for hot humid weather when you need to cool and
dehumidify the room. By default, the room temperature is
displayed. Light (
S
) is on. To set the required temperature,
press the
+
(
E
) or
-
(
F
) buttons until the required temperature
is displayed (to switch between °Fand °C, press the
E
and
F
buttons together for a few seconds). Light (
T
) comes on
and light (
S
) goes off. Fifteen seconds after setting the
temperature, the display swit-ches back to room temperature.
Light (
S
) comes on again. You can adjust temperature in air
conditioning mode only. Then select the fan speed by pressing
the FAN button (
C
) untilthe indicator light corresponding to
the required fan speed lightsup:
MAX:
the air conditioner operates at maximum to reach
the required temperature as rapidly as possible.
MED:
reduces noise levels but still maintains a good level
of comfort
SILENT:
for silent operation
Description of the control panel
A
ON/OFF button
B
MODE selection button
Air conditioning, dehumidifying, fan.
C
Fan speed selection button
(MAX/MED/SILENT)
D
Timer button
E
Programmed operation increase temperature/time
button
F
Programmed operation decrease temperature/time
button
G
Display: Displays the temperature values set, room
temperature and the programmed operating time
H
Timer in operation indicator light
I/L/M
Fan speed lights
N
Fan mode light
O
Air-conditioning mode light
P
Dehumidifying mode light
Q
Alarm light
R
Remote control signal receiver
S
Light: displays room temperature
T
Light: displays set temperature
Important!
Never turn the air conditioner off by unplugging from the mains. Always press the
button, then wait for
a few minutes before unplugging. This allows the appliance to perform a cycle of checks to verify operation.
R
C
I
F
E
A
G
B
O
P
L
Q
M
S
T
D
N
H
