17
TECHNICAL SpECIFICATIONS
Outlet voltage
see rating plate
Maximum absorbed power
in air conditioning
“
Maximum absorbed
power in heating
“
Refrigerant
“
Cooling capacity
“
Heating power
“
LIMIT CONDITIONS
Temperature of room
in air conditioning 70-95°f (21-35°C)
Temperature of room
in heating
50-81°f (10÷27°C)
neVer TrAnSporT or TUrn The Ap-
plIAnCe UpSIDe DoWn or on ITS SIDe.
If ThIS oCCUrS, WAIT 6 hoUrS Before
TUrnInG The ApplIAnCe on, 24 hoUrS IS
reCoMMenDeD. After the unit has been on
its side, oil needs to return to the compressor
to ensure proper function. Without allowing
the unit this time (6-24 hours) The unit may
function for only a short time, and then the
compressor will break down from lack of oil.
Transport, filling, cleaning, recovery and di-
sposal of refrigerant should be performed by
a technical service centre appointed by the
manufacturer only.
The appliance should be disposed of by a specia-
list centre appointed by the manufacturer only.
This appliance is equipped with a 3 prong
grounded plug. The plug must be connec-
ted into an outlet that is properly installed
and grounded in the accordance with all
local codes and ordinances. Do not mo-
dify the plug provided with the appliance.
If it will not fit the outlet, have a proper
outlet installed by a qualified electrician
or relocate the unit to a proper outlet.
If the household electrical supply does not
meet the above specifications, or if you
are not sure your home has an effective
electrical ground, have a qualified elec-
trician or your local electrical utility com-
pany check it and correct any problems.
SAFETY pLUG
The appliance is fitted with a safety plug to
protect the power cable. If power is cut off, un-
plug from the outlet and make sure the power
cable is undamaged. If the cable is damaged,
call the service center immediately. If power
cuts off frequently and the power cable is
undamaged, contact a qualified electrician.
OpERATION OF THE SAFETY pLUG
If the safety device incorporated in the plug
trips and cuts off the power supply, check
that the power cable and plug are not dama-
ged. If the power cable is undamaged, to re-
store operation press the “reSeT” button.
To verify correct operation of the plug, press
the “TeST” button periodically and make
sure the appliance disconnects. If this is not
the case, contact the service center. To re-
store operation, press the “reSeT” button.
