22
"SLEEP" signal lamp
Min. speed signal lamp
Air-cooling signal lamp
ON timer signal lamp
CONTROL PANEL
ON/OFF Timer key
"SLEEP" key
SETTING THE TIMER
Ther programmer/timer, like all clocks, must be
set to the exact time. If for example it is 4.00 p.m.
(16.00), turn the dial in a clockwise direction
(following the direction of the arrow) until the
number 16 is lined up with the tringular pointer
(the arrows indicates 4:00 p.m. approximately).
N.B.: Never turn the dial in anti-clockwise direction!
The timer is in effect, an electric clock and works
only if the plug is connected to the power supply.
Whenever the plug is disconnected or there is a
power failure, the programmer stops (the clock is
then "slow" and must be re-set.
Select operation "
with timer
" or "
without timer
".
21
20
19
16
Example: from 7 p.m. to 9 p.m.
The air-conditioner will now switch on each day at
the selected times.
N.B.: If you wish to override the programmed
operating times, simply press the ON/OFF
timer key (the timer signal lamp ON will go
out).
Timer
Thermostat
slider
Air-cooling
signal lamp
ON/OFF key
Automatic function signal lamp
Signal lamp indicating 3 min. wait (flashing) or
working appliance (on continuously)
Signal lamp mains (continuous light) or
malfunction (flashing light)
Fan speed key
Air-cooling key
Max. speed signal lamp
Pointer
21
20
19
16
Function
O
FF
ON
OF
F
OPERATION WITH TIMER
1) Select the desired function as shown in the
chart overleaf.
2) Press the TIMER key, the "TIMER ON" signal
lamp will come ON.
3) Make sure that the timer indicates the correct
time (see instructions on setting).
4) Set the operating times by pushing out the
notches on the dial corresponding to the
period required (each notch represent 15
mins).
OPERATIONG WITHOUT TIMER
1) Press the TIMER ON key again, the TIMER ON
signal lamp will go out.
2) Select the desired function as shown in the
chart on page. 9.
For technical reasons, the temperature is not
expressed in degrees but by a line increasing in
thickness. We therefore recommend that when
starting up the appliance, the thermostat be
turned to maximum (thick green line = maximum
cold). When the desired temperature has been
reached move the thermostat slider slowly away
from the maximum cold position until the
appliance is switched off by operation of the
thermostat. In this way the appliance has been
programmed with the exact temperature degree
required, which is then maintained automatically
by the thermostat.
