DeLonghi Maestosa EPAM96X.75, Инструкция по эксплуатации

Страница: 15 / 34

15
Important
Make sure the hole in the funnel shown in fig. 33 is clean.
Please note!
• The milk must be poured into the funnel when the steam
spout and stirrer are already in place. Do not exceed the
level marked on the carafe. Increase or
reduce the quantity of hot chocolate powder according to
taste.
• To use water instead of milk, follow the instructions for
milk.
33 34
• To prepare hot chocolate correctly, first pour the milk (or
water) into the funnel, then add the hot chocolate or cocoa
powder.
6. "Close lid and insert carafe. Press OK to start": close the lid
and attach the carafe to the connection nozzles (A11) (fig.
34): the appliance beeps (if the beep function is enabled);
7. Press "OK" to start the function; the appliance starts mix-
ing the hot chocolate powder then delivers steam to heat
it.
Please note!
To stop making chocolate, press "Stop" and "Cancel".
8. "Your beverage is ready!": Press "Done" to go back to the
homepage (main screen).
The chocolate is ready to be poured into the cup.
Please note!
• If you have modified the cups or density settings, the mes-
sage: "Save new settings?" is displayed.
• While making the chocolate, the carafe and lid become
very hot. Hold by the handle only to remove the carafe and
pour the chocolate.
• While making the hot chocolate, it is normal for steam to
come out of the holes in the chocolate carafe lid.
• Heating the milk causes splashes inside the carafe. This is
normal.
• The quantity of hot chocolate in the cup varies according to
the density selected. The quantity is less with a high densi-
ty than with a low density.
• You are recommended to clean the carafe as soon as pos-
sible (see section “17.11 Cleaning the “Mix Carafe” (E)”).
11. MAKING COLD BEVERAGES
11.1 Making cold coffee
To make the beverage, press the image on the homepage (B)
corresponding to cold coffee and proceed as follows:
1. "BEVERAGE SETTINGS": The parameters that can be cus-
tomised according to your tastes appear on the display:
"Cups"
"Froth"
(MAX position recommended)
"Aroma"
(MAX position recommended)
"Coffee type"
Please note!
If you use pre-ground coffee, you can only make 1 cup of coffee
(
);
2. Press "Next" to enter the guided procedure;
3. "Add aero stirrer to carafe (step 1 of 4)": lift the carafe lid
(E1) (fig. 35), press the release slide (E8)(fig. 27) and ex-
tract the carafe funnel (E3) (fig. 28). Make sure the aero
stirrer (E6) is inserted (fig. 35), then attach the assembled
funnel to the carafe;
Please note!
• To prepare the beverage correctly, make sure the steam
spout (E4) is not inserted.
• Never insert the lid (E1) with funnel (E3) and aero stirrer
(E6) to the connection nozzles (A11) without the carafe
(E7) as direct contact with the stirrer in movement could
be dangerous.
35 36