12
4. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problemcannot be resolved as described, contact Customer Service.
PROBLEM
CAUSE
SOLUTION
No discharge of air
Cord is not plugged in
Make sure power cord is plugged in and the swi-
tchisON
Power isnot ON
Turn the unit ON by pressing the button
( B1 on the control panel or D1 on the remote
control)
The appliance switches off
The auto shutoff timer was set
Turn the appliance ON and check that the auto off
symbol is shutoff
Présence d
’eau sous le réservoir
Lorsqu
’on extrait complètement le rés-
ervoir sans attendre quelques minutes,
l
’eau résiduelle présente sur le panneau
évaporatif dégouline dans le logement
réservoir
Essuyer le logement avant de réinsérer le réserv-
oir. Pour le remplissage, toujours suivre les indi-
cations du chap. 3.
PROBLEM
CAUSE
SOLUTION
Excessive humidity in the room
In Cooler/Humidifying function, the ap-
pliance produces moisture as a result of
evaporative cooling. This is normal
The appliance cools best in dry climates. If the
ambient humidty level is high (60% or above) re-
frain from using the cooler/humidifying function
Make sure the window/doors are open and there
is adequate cross-ventilation in the room so
that the air can circulate better. Prefer the
“fan”
function
Odors and colored water
When the appliance is new
At first use, the appliance will have an odor,
which will dissipate within a few hours of initial
use. The color in the water will also dissipate after
afewuses.
Algae or mold due to moist parts. In very
damp conditions, algae may form due to
moisture
Check the Honeycomb Cooling Pad (A12), water
tank (A7) and other cooler parts. If you see mold
spots or algae issue, use a damp cloth to wipe
away the algae until all spots have disappea-
red. Make sure all parts are clean and dry before
storage. Contact Customer Service if problem
persists. If the Honeycomb Cooling Pad (A11) has
algae or mold, change it with a new one
Remote control does not work
Remote control battery is incorrectly in-
serted in the battery compartment
Check the battery is correctly inserted fol-
lowing the polarity guide inside the battery
compartment.
Remote control battery is exhausted
Replace with a new battery
Damaged remote control
If replacing new battery in the correct position
doesnot work, contact Customer Service
