DeLonghi ECAM51X.55 series, Инструкция по эксплуатации

Страница: 25 / 29

24
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
Fill tank Insufficient water in the tank (A18). Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (fig. 3B).
Insert tank The tank (A18) is not correctly in place. Insert the tank correctly and press as far as it
will go (fig. 3B).
Empty grounds container The grounds container (A20) is full. Empty the grounds container and drip tray
(A24), clean and replace. Important: when
removing the drip tray, the grounds contain-
er must be emptied, even if it contains few
grounds. If this is not done, when you make
the next coffees, the grounds container may fill
up more than expected and clog the machine.
Insert grounds container After cleaning, the grounds container (A20)
has not been replaced. Remove the drip tray (A24) and insert the
grounds container.
Add pre-ground coffee
ESC to cancel The “pre-ground coffee” function has been se-
lected without placing any pre-ground coffee
in the funnel (A6). Place pre-ground coffee in the funnel or dese-
lect the “pre-ground” function (fig. 11).
Add pre-ground coffee
ESC OK
A LONG coffee with pre-ground coffee has
been requested Put one level measure of pre-ground coffee
into the pre-ground coffee funnel (A6) and
press
(B3) to continue and complete
preparation.
Fill beans container
ESC to cancel The coffee beans have run out. Fill the beans container (A4) (fig. 8).
The pre-ground coffee funnel (A6) is clogged. Empty the funnel with the help of the brush
(C5) as described in section “4.2 Cleaning the
pre-ground coffee funnel”.
Ground too fine
Adjust mill
ESC to cancel The grinding is too fine and the coffee is deliv-
ered too slowly or not at all. Repeat coffee delivery and turn the grinding
adjustment dial (A3) (fig. 7) one click clock-
wise towards “7” while the coffee mill is in
operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section “5.1 Adjusting the coffee mill”). If the
problem persists, make sure the water tank
(A18) is fully inserted.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery. Insert the hot water spout (C6) in the appli-
ance and deliver a little water until the flow
becomes regular.
Less coffee
ESC to cancel Too much coffee has been used.
Select a lighter taste by pressing (B3)
or reduce the quantity of pre-ground coffee.
20. DISPLAYED MESSAGES