12
3. Release the icon: the icon blinks and the appliance starts
delivering the beverage;
4. Once the amount of liquid in the cup is as desired (milk
and/or coffee), press the selected icon a second time: the
flow will cease.
The quantity of the beverage in the cup has now been
programmed.
14.5 Cleaning the milk container after use
Important! Danger of scalding
When cleaning the internal tubes of the milk container (D), a
little hot water and steam leak out of the milk spout (D5). Take
care to avoid contact with splashes of water.
Every time a drink is prepared with milk, the lid of the milk con-
tainer (D2) must be cleaned afterwards. Clean as described to
eliminate all milk residues (or press
ESC
(B14) to postpone
the cleaning operation until later):
1. Leave the milk container (D) in the machine (it does not
have to be emptied);
2. Place a cup or other recipient under the frothed milk spout;
3. Turn the froth adjustment dial (D1) to "CLEAN" (fig. 19).
Cleaning stops automatically;
20
19
4. Turn the dial back to one of the froth selections;
5. Remove the milk container and always clean the steam
connection nozzle (A8) with a sponge (fig. 20).
Please note!
• To prepare a number of cappuccinos or milk-based coffees,
clean the milk container after preparing the last of the
beverages: in this instance press
ESC
(B14) to go back
to the main menu.
• The milk container can be kept in the refrigerator.
• In certain cases, the appliance will need to heat up before
the container can be cleaned.
15. DELIVERING HOT WATER
Important! Danger of scalding.
Never leave the machine unattended when hot water is being
released.
1. Make sure the hot water spout (C6) is attached correctly;
2. Place a container under the water spout (as close as possi-
ble to avoid splashes) (fig. 5);
3. Press
ESC
(B14);
4. The machine delivers about 250 ml of hot water, then de-
livery stops automatically. The icon blinks during delivery,
To interrupt the flow of hot water from the spout, press
ESC
(B14).
Please note:
• If "Energy Saving" mode is active, there may be a few sec-
onds pause before hot water is delivered.
16. CLEANING
16.1 Cleaning the machine
The following parts of the machine must be cleaned regularly:
- the appliance’s internal circuit;
- coffee grounds container (A11);
- drip tray (A15) and condensate tray (A10);
- water tank (A17);
- coffee spouts (A9);
- pre-ground coffee funnel (A4);
- infuser (A20), accessible after opening the infuser door
(A19);
- milk container (D);
- hot water connection nozzle (A8);
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coffee machine. With De’Longhi superautomatic coffee
machines, no chemical products are required for cleaning
purposes.
• None of the components of the appliance can be washed
in a dishwasher with the exception of the drip tray grille
(A14) and milk container (D).
• Do not use metal objects to remove encrustations or coffee
deposits as they could scratch metal or plastic surfaces.
16.2 Cleaning the internal circuit
If the appliance is not used for more than 3/4 days, before using
it again, we strongly recommend switching it on and:
• running 2/3 rinse cycles by pressing
OK (B15);
• release hot water for a few seconds (section “15. Delivering
hot water”).
