DeLonghi ECAM28.46X, Инструкция по эксплуатации

Страница: 21 / 24

20
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK Insufficient water in the tank. Fill the tank with water and/or insert it
correctly, pushing it as far as it will go until it
clicks into place.
EMPTY GROUNDS CONTAINER The grounds container (A22) is full. Empty the grounds container and drip tray,
clean and replace. Important: when removing
the drip tray, the grounds container must be
emptied, even if it is not completely full.
If this is not done, when you make the next
coffees, the grounds container may fill up more
than expected and clog the machine.
GROUND TOO FINE ADJUST
MILL The grinding is too fine and the coffee is
delivered too slowly or not at all.
The grinding is too fine and the coffee is
delivered too slowly or not at all.
Repeat coffee delivery and turn the grinding
adjustment dial (fig. 10) one click clockwise to-
wards “7” while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see the section:
“Adjusting the coffee mill” on page 12). If the
problem persists, make sure the water tank is
fully inserted, press the button and
deliver a little water from the spout.
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
been replaced.
Remove the drip tray and insert the grounds
container.
ADD PRE-GROUND COFFEE With the pre-ground function selected,
pre-ground coffee has not been poured into
the funnel.
Place pre-ground coffee in the funnel or
deselect the “pre-ground” function (fig. 17).
DESCALE The machine must be descaled. The descaling procedure described in the
section “Descaling” needs to be performed as
soon as possible (page 17).
LESS COFFEE Too much coffee has been used.
Select a milder taste by pressing the dial
(fig. 9) or reduce the quantity of pre-ground
coffee.
FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container (fig. 13).
The pre-ground coffee funnel is clogged. Empty the funnel with the help of a brush as
described in the section “Cleaning the pre-
ground coffee funnel”.
INSERT INFUSER ASSEMBLY The infuser has not been replaced after
cleaning.
Insert the infuser as described in the
paragraph “Cleaning the infuser”.
INSERT TANK The tank is not correctly in place. Insert the tank correctly and press as far as it
will go.