DeLonghi ECAM23.46 Series, Инструкция по эксплуатации

Страница: 20 / 22

19
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
GROUND TOO FINE ADJUST
MILL The grinding is too fine and the coffee is deliv-
ered too slowly or not at all. Repeat coffee delivery and turn the grind-
ing adjustment dial (A2) (fig. 11) one click
clockwise towards 7 while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click (see section “8.4 Adjusting
the coffee mill”). If the problem persists, make
sure the water tank (A10) is fully inserted.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing the flow. Insert the hot water spout in the appliance and
deliver a little water until the flow becomes
regular.
DESCALE The machine must be descaled. The descaling procedure described in section
“12. Descaling” needs to be performed.
LESS COFFEE Too much coffee has been used. Select a milder taste by pressing the dial
(B6) (fig. 8) or reduce the quantity of
pre-ground coffee.
FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container (A7) (fig. 12).
The pre-ground coffee funnel (A6) is clogged. Empty the funnel with the help of the brush
(C5) as described in section “11.8 Cleaning the
pre-ground coffee funnel”.
INSERT INFUSER ASSEMBLY The infuser (A12) was not replaced after
cleaning. Insert the infuser as described in section “11.9
Cleaning the infuser”.
INSERT TANK The tank (A10) is not correctly in place. Insert the tank correctly and press as far as it
will go (fig. 3B).
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “11. Cleaning”. If the
message is still displayed after cleaning, con-
tact a customer service centre.
REPLACE FILTER The water softener filter (C4) is spent. Replace the filter or remove it as described in
section “14. Water softener filter”
SET DIAL TO CLEAN Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned. Turn the froth adjustment dial (D1) to the
CLEAN position.
INSERT WATER SPOUT The hot water spout (C6) is not inserted or is
inserted incorrectly. Insert water spout as far as it will go.
INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container (fig. 20) as far as it
will go.
WATER CIRCUIT EMPTY FILL
WATER CIRCUIT
HOT WATER
Confirm?
The water circuit is empty.
Press (B9) to deliver water from the hot
water spout (C6) until it flows out normally. If
the problem persists, make sure the water tank
(A10) is fully inserted.