DeLonghi ECAM23.46 Series, Инструкция по эксплуатации

Страница: 16 / 22

15
10. Put the water tank back.
11.10 Cleaning the milk container
Clean the milk container (D) after use, every time that milk is
prepared, as described below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 32);
3. Turn the froth adjustment
dial (D1) anticlockwise to
the "INSERT" position (fig.
33) and pull off upwards;
4. Wash all the components
thoroughly with hot
water and mild wash-
ing-up liquid. All com-
ponents are dishwasher
safe, but must be placed
in the top basket of the
dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 34). If necessary, scrape the
groove with a toothpick;
34 35
5. Rinse inside the froth adjustment dial seat with running
water (fig. 35);
6. Check that the intake tube and milk spout are not clogged
with milk residues;
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube;
8. Place the lid back on the milk container (D3).
11.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A13)
with a sponge to remove milk residues from the gaskets (fig.
23).
33
12. DESCALING
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• It is important to use De’Longhi descaler only. Using un-
suitable descaler and/or performing descaling incorrectly
may result in faults not covered by the manufacturer's
guarantee.
• Descaler could damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler De’Longhi descaler
Container Recommended capacity: 1.8l
Time ~45min
Descale the machine when the message "DESCALE" flashes on
the display (B1).
1. Turn the machine on and wait until it is ready for use;
2. Press the
P
button (B4) to access the menu;
3. Turn the selection dial (B2) until "Descaling" is displayed;
4. Select by pressing the
button (B9). "Descale Con-
firm?" appears on the display (B1). Press again to
enable the function;
5. "EMPTY DRIP TRAY" is displayed, alternating with "RE-
MOVE FILTER" (if the filter is present) and "Add descaler.
Confirm?" is displayed.
6. Empty the water tank (A10) completely and remove the
water softener filter (C4) (if present). Empty the drip tray
(A19) (fig. 24) and grounds container (A15), then put them
back in the appliance;
7. Pour the descaler into the tank up to level A (corresponding
to a 100ml pack) marked on the side of the tank (fig. 36),
then add water (1 litre) up to level
B (fig. 37) and put the
water tank back;
36
B
A
A
37
B
A
B