DeLonghi ECAM20.11 Series, Руководство пользователя

Страница: 37 / 76

16
Please note:
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 32.
32
8. Once inserted, make sure the two coloured buttons have
snapped out (fig. 33).
33
PUSH
9. Close the infuser door.
10. Put the water tank back.
15. DESCALING
Descale the appliance when the light (B5) (fig. 34) on the
control panel flashes.
34
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• You should use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer’s guarantee.
1. Turn the appliance on and wait until it is ready for use.
2. Empty the drip tray (A17) and grounds container (A13) and
put both back in the machine.
3. Empty the water tank (A9) completely and remove the
water softener filter (C4), if present.
4. Pour the descaler (C3) into the tank up to level
A
(corre-
sponding to a 100 ml pack) marked on the back of the tank,
then add a litre of water up to level
B (fig. 35) and put the
water tank back in the appliance.
1,8 l
36
B
A
A B
35
. Place a container with a minimum capacity of 1.8 litres
under the cappuccino maker (A18) and coffee spouts (A12)
(fig. 36).
6. Wait for the coffee lights to come on steadily.
7. Press and hold the
button (B5) for at least 5 sec-
onds to confirm that you have added
the solution and begin the descaling procedure. The light
in the button comes on steadily to indicate that the desca-
ling programme has begun.
8. The light flashes to indicate the hot water/steam dial
(A19) must be turned to the I position.
Important! Danger of burns
Hot water containing acid flows from the cappuccino maker and
coffee spouts. Take care to avoid contact with splashes of this
solution.
9. When the dial has been turned to the l position, the des-
cale programme starts and the descaler liquid comes out of
the cappuccino maker and coffee spouts. A series of rinses
and pauses are performed automatically to remove all the
scale residues inside the coffee machine.
After about 25 minutes, descaling stops and the and
lights flash on the control panel. Turn the hot water/steam dial
to the
0 position.
10. The appliance is now ready for rinsing through with clean
water. Empty the container used to collect the descaler
solution. Extract the water tank, empty, rinse under run-
ning water, fill with fresh water up to the MAX level and
put back in the appliance: the
light flashes.
Small lever
Large lever