3.
Use the
key to highlight the default material
(Oak) if you wish to change it to a
different material. Press the
SELECT
key to get into the
SELECT MATERIAL
sub menu.
4.
Use the
keys to highlight
the material you are testing. Press the
SELECT
key to
choose that material. This will bring you back to the main %MC
READ
screen.
You may begin taking readings by inserting the pins into the material and pressing the
SELECT
key. This will display a %MC reading. If you wish to hold a reading on screen,
press the
SELECT
key again; otherwise remove the pins from the material being tested
and take another reading.
TO SET THE ALARM IN BASIC PIN MODE:
1.
If you wish to set the alarm
to beep after a pre-selected %MC value is reached, use the
keys from the %MC screen to highlight the
ALARM
. Press the
SELECT
key to
enter the alarm sub menu.
2.
The default status of the alarm is “OFF
.” Press the
SELECT
key to turn it on.
3.
After the alarm is turned on, use the
keys
to scroll up or down to a higher or
lower alarm value.
4.
After you have selected the alarm value
, use the
key to highlight
DONE.
Press
SELECT
to get back to the %MC
READ
screen.
Default alarm settings in pin mode are as follows for different materials:
All wood materials:
12%
Sheetrock/Gypcrete:
1.0%
Plaster:
68 (on the 0-100 relative scale)
Concrete:
68 (on the 0-100 relative scale)
Note: The default alarm setting in scan mode is 300.
Содержание navigator pro
Страница 28: ...Blank page...
